A location is used to give candidates access to start a test or review moment only from a certain IP address (range). This prevents a candidate from starting or viewing the test if it is not in the desired location.
Set up locations
How to create a location can be found in the article Locations.
Test moment from a location
In order for a test moment to take place from one or more specific locations, a number of components must be set for this.
When creating the test moment, there is the setting 'Default location'. By choosing a location here, candidates will be linked to this location by default when they are added to the test moment. This can of course be changed to another location when linking.
On the same page, the following option is available:
Attention!
This setting is only visible if locations with IP addresses have actually been set.
By choosing to limit the administration to the set location(s), the test can only be started from the linked location(s). The candidate can therefore only start the test from the location to which he/she is linked.
After these components have been set as desired, the candidates and any supervisors can be linked to the test moment. During linking, the location can be chosen, the previously set default location is linked to the candidate by default, but this can be adjusted. The location must be chosen by a supervisor.
In this way it can also be set that the candidates from the test moment are in different rooms, for example, and that a supervisor is linked to each room. This way, the supervisor only sees the candidates that are linked to the same location. If the supervisor is not linked to a location, then all candidates are visible.
View moment from a location
The same applies to a review moment from a location as to a test moment. It must be set that the inspection may only take place from a selected location and the candidates and possibly. Supervisors must be linked to a location.
Disclaimer: This text was automatically translated from the Dutch version.